How To Make A Garrison Cap Out Of Paper

Table of contents:

How To Make A Garrison Cap Out Of Paper
How To Make A Garrison Cap Out Of Paper

Video: How To Make A Garrison Cap Out Of Paper

Video: How To Make A Garrison Cap Out Of Paper
Video: Military Cap | Origami Tutorial | Easy | For Beginner 2024, December
Anonim

Paper is readily available and easy to work with. Beautiful crafts are made from it. Why not make a paper cap with your baby? Time will pass with benefit, and the craft will turn out amazing.

How to make a garrison cap out of paper
How to make a garrison cap out of paper

It is necessary

  • - paper;
  • - glue;
  • - scissors.

Instructions

Step 1

Fold a rectangular piece of paper in half. Of course, you can also use a regular A4 sheet of paper: in this case, the cap will turn out to be small. To make the craft come out in normal sizes, use a rectangular Whatman paper, newspaper or gift paper.

Step 2

Arrange the paper so that the narrow side is at the top and bottom. Fold the sheet in half. Be sure to check that the sides match, then iron the fold line well.

Step 3

Place the folded sheet of paper in front of you so that the bend line is on top. Then fold the top corners towards the middle for a pointed hat.

Step 4

After that, bend the bottom edge of the sheet up, and then bend the corners inward. Turn the workpiece over to the other side and do the same operations. Be sure to glue the corners, because otherwise they will bump and bend, because of which the craft will lose its appearance.

Step 5

After the glue dries, fold the cap in half and pull lightly on the center section. The corners of the folded cap should cover each other. Such manipulations will strengthen the structure.

Step 6

The pilot can be made in a slightly different way. To do this, cut a square out of paper. Then bend the sheet horizontally in half, and then fold the edges to the middle.

Step 7

Bend the top corners inward and straighten them. Following this, fold the edges so that you get a rectangle, and turn the workpiece over. Bend the resulting rectangle several times, straighten the cap and slightly flatten it: the craft is ready.

Recommended: