Lightweight hats are comfortable in various conditions in order to protect the head. This can be protection from sunlight in order to avoid overheating of the head, or as protection from various pollutants - dust, various small splashes of dirt, paint droplets from a spray bottle during painting; when whitewashing the ceiling, walls above the head. If an ordinary panama or cap is not available, or it is a pity to spoil them, then you can make a hat out of paper, for example, from a spread sheet. Let's make a garrison cap.
It is necessary
newspaper sheet
Instructions
Step 1
Take one sheet of newspaper. Usually it is already folded in half, that is, it has a fold along which the newspaper is folded during production in a printing house. Place the folded sheet in half with the fold line horizontally and further away from you.
Step 2
Take the upper right and left corners and fold them into right angles symmetrically to the center, about a third of the width of the newspaper. A semblance of a trapezoid is formed.
Step 3
Fold the loose top layer of the bottom edge upwards so that it folds equally twice. The first time - in half to the bottom of the right angles formed from the previous fold. The second is to repeat the twist by the same amount even higher. The resulting strip will partially overlap the corner folds. The design itself will resemble a boat folded out of paper.
Step 4
Without changing the top-bottom orientation, turn the newspaper over to the other side. Thus, only the right and left sides are swapped.
Step 5
Fold back the strips on the left and right, each about a sixth of the width, so that vertical, parallel fold lines form.
Step 6
Roll the bottom edge horizontally 2 times away from you. First, in half, and during the second turn, insert the first fold of this step and insert it behind the flaps-pockets from similar two turns in the third step of this instruction. The assembly is complete.
Step 7
Add volume to the cap and put it on. A step-by-step scheme for folding the cap is shown in the figure.
