How To Knit A Finger On A Mitten

Table of contents:

How To Knit A Finger On A Mitten
How To Knit A Finger On A Mitten

Video: How To Knit A Finger On A Mitten

Video: How To Knit A Finger On A Mitten
Video: Knitting Thumbs and Fingers: How to Knit Thumbs for Mittens 2024, December
Anonim

Knitting mittens is an interesting and necessary activity if you prefer hand-knitted things. To knit a finger beautifully, you need to knit the rest of the mittens exactly in size.

How to knit a finger on a mitten
How to knit a finger on a mitten

It is necessary

yarn, five needles No. 3

Instructions

Step 1

Knit a fingerless mitten. Knit 4 cm mitten cuffs on 44 loops. Create a thumb wedge. To do this, knit 2 rows with front loops, then mark the second and fourth loops on the inside of the mitten. In the third row after the first and before the second marked loops from the broach, add 1 front crossed loop and then knit 2 rows without increments. So repeat until the total number of loops is 15.

Step 2

Knit two rows without increments and leave 15 wedge loops on a safety pin or auxiliary thread. Then tie the thumb bridge by typing 7 loops over the left loops and making a small wedge. Then knit straight on 44 sts 4 cm to the beginning of the top of the mitten. Then trim the upper part by making subtractions. The length of the mitten without the cuff should be 12-13 cm.

Step 3

Now proceed directly to the finger of the mitten. To do this, first dial on one knitting needle 7 loops from the bridge, add 15 loops of the thumb wedge. Distribute all 22 loops on 3 needles. Knit one row with knit stitches.

Step 4

Make a small wedge on the seven stitches, like on the bridge of the thumb. To do this, knit the loop in front of the jumper and the first loop of the jumper together with a tilt to the left. To do this, remove 1 loop, as in knitting, knit the next loop with the front one, pull the previously removed one through it. Next, knit the last loop of the jumper and the next one after it with the front one. Repeat these decreases in each next row until only the middle loop remains. As a result, 16 loops should remain on the needles. Next, knit straight, without knitting 1 cm to the end of the finger.

Step 5

Start decreasing the loops to form the tip of your finger. Knit the last two stitches from each knitting needle together. Repeat decrements until only 6 stitches remain on the needles. Now cut the thread and pull off the remaining 6 stitches. To do this, pull the cut thread through them. Secure it to the wrong side.

Recommended: