If you have an old, but quite working camera (for example, Zenith), then a pretty good prospect opens up to insert digital filling into such an old camera. At the same time, the digital filling must be working.
It is necessary
Old camera, working digital camera, soldering iron, screwdrivers
Instructions
Step 1
Take an old camera as a basis. Disassemble the device completely. Remove all objective lenses, video finder. Be sure to remove the motors that control the focal length and focus.
Step 2
Remove the central shutter from the lens, rotate it 180 degrees and place it in front of the IR filter, which is directly adjacent to the sensor. After disconnecting the wire that leads to the motors and limit switches, the equipment is fully functional. It should be noted, however, that the equipment does not respond to the lack of a lens.
Step 3
Install the digital image sensor in the old camera so that it aligns the image sensor with the shutter aperture in order to avoid vignetting of the corners.
Step 4
Move the container with the matrix closer to the wall of the device by about 5 mm. To do this, file the supports on which it is attached, and carefully shorten the glass of the rim.
