You can draw a pipe in different ways, but it is better to follow the advice clearly. Choose the right source materials, prepare the place for work. Only after proper preparation can you start drawing.
It is necessary
ruler, pencil, eraser, markers
Instructions
Step 1
To draw a pipe, prepare the necessary materials and work area. Prepare a table or other smooth surface to draw on. Also prepare pencils, markers or paints, a ruler, and a sheet of good paper.
Step 2
Lay out a sheet of paper on the work surface and secure it well. Secure the sheet with paper clips or simply place old books around the edges of the sheet.
Step 3
Use a simple pencil to sketch your drawing, see what comes out. If the free drawing is successful, proceed to the next stage. If your freestyle drawing doesn't work, try drawing a pipe with a ruler.
Step 4
Take a ruler and measure five centimeters from the bottom of the sheet - make a small mark, then measure five centimeters on each side of the sheet - and put small dots. Now connect the obtained points in series, one by one.
Step 5
In the resulting rectangle, measure two centimeters from the bottom - and put a point. Then from the resulting point, step back two centimeters to the left - and put a small mark. Now connect these two points with a horizontal line.
Step 6
From the resulting base of the pipe, set aside five centimeters upwards - and put a mark in the form of a dot. Then draw a horizontal line parallel to the base of the pipe. Mark a point on the top line opposite the lower right edge of the pipe, and then make the same mark opposite the lower left edge of the pipe.
Step 7
Now connect the bottom right point of the pipe to its top using a vertical line. Then connect the left point to the top - and remove the extra protrusions. Color the pipe with felt-tip pens or paints. For persuasiveness, paint in a light plume of smoke that coils from the chimney. Paint the smoke with gray paint, or just thin the black paint with water.
