How To Make A Bracelet From An Adhesive Tape Base

Table of contents:

How To Make A Bracelet From An Adhesive Tape Base
How To Make A Bracelet From An Adhesive Tape Base

Video: How To Make A Bracelet From An Adhesive Tape Base

Video: How To Make A Bracelet From An Adhesive Tape Base
Video: Make SNAP BANDS from Unusual Materials 2024, December
Anonim

The most common cardboard base left over from used scotch tape can be turned into an original and cute bracelet. This accessory will be a worthy addition to your everyday wardrobe.

How to make a bracelet from an adhesive tape base
How to make a bracelet from an adhesive tape base

It is necessary

  • -base from scotch tape
  • - wide braid
  • -felt
  • -wavy braid
  • -glue

Instructions

Step 1

Trying on the base from the tape on the wrist. If the size is too large, then cut off the excess and glue it with tape. If the shape after that became not quite round, then we straighten it with our hands.

Image
Image

Step 2

We take the tape a little wider than the base from the tape and cut off a length slightly longer than the circumference of the base. Cut a piece of the same size from the felt. We glue the cut tape on the outside of the base, and the piece of felt on the inside.

Image
Image

Step 3

We sew the braid and felt with a decorative seam, for example, "over the edge". You can also insert wavy tape between them. Done!

Recommended: