How To Make A Fan Using Disposable Forks

Table of contents:

How To Make A Fan Using Disposable Forks
How To Make A Fan Using Disposable Forks

Video: How To Make A Fan Using Disposable Forks

Video: How To Make A Fan Using Disposable Forks
Video: How To Make a Plastic Fork Fan | Best From Waste 2024, December
Anonim

The bright sun pleases us with its warmth, but in the sultry summer it will bake seriously. And then every little princess will really need a fan, but not a simple one, but worthy of her crowned person!

fan
fan

It is necessary

  • - 21-25 disposable forks
  • - 1 m wide lace
  • - braid
  • - lace butterfly or artificial flower
  • - unnecessary CD
  • - glue gun or Moment
  • - thick white cardboard
  • - packing corrugated board
  • - scissors, pencil, glass

Instructions

Step 1

Place the unwanted CD on a piece of cardboard and trace around it with a pencil. Place an empty glass on a sheet of corrugated cardboard and circle it too. Cut out the resulting circles along the contour and cut each one exactly in half.

Step 2

Glue the smaller semicircle (the one made of corrugated cardboard) to the middle of the larger one. Around it with rays, lay out and glue disposable forks, so that their handles rest against the corrugated cardboard, and the extreme teeth are in contact with each other (there must be an odd number of forks). Grease the second large semicircle with glue and glue it on top. Wait until the glue is completely dry.

Step 3

Take the lace and thread it between the handles of the forks through one so that it either overlaps the handles or dives under them. Trim the ends of the lace, leaving 1 cm allowance on each side. Fold in these allowances and glue them to the back of the outer forks. Pass the remaining lace between the teeth so that the outer teeth of each fork are under the lace ribbon, and the inner ones are on top of it. Secure the ends of the lace in the same way.

Step 4

Turn the fan over with the back side and fasten the lace with small drops of glue so that it does not slip off the forks.

Step 5

Just below the teeth of the forks, I pasted a floral tape. Decorate the cardboard semicircle with it, laying the flowers tightly one to one so that the cardboard does not show through.

Step 6

Glue a beautiful butterfly or flower in the middle of the fan. Optionally, you can decorate your fan with beads or beads, rhinestones or buttons.

Recommended: