The legendary Soviet tank T-34 is one of the most reliable combat vehicles of the Great Patriotic War. He can be seen in films and paintings. Quite often "thirty-fours" often stand on pedestals at war memorials. You can draw such a tank with a pencil.
It is necessary
- - pencil;
- - paper;
- - a picture with a T-34 tank.
Instructions
Step 1
When drawing military equipment, the most important thing is to correctly depict the main details and be able to omit the little things. Of course, if this is not a technical drawing, where every detail is important. You can draw a T-34 tank from different angles. If you are not very experienced yet, choose the position "in profile", because in this case you can more or less accurately determine the ratios of parts without regard to perspective.
Step 2
Tank T-34 without a cannon can be inscribed in a rectangle. Estimate the approximate ratio of the length of the tracks to the height of the tank to the hatch cover. With a thin pencil, sketch out such a rectangle. It is better to lay the sheet horizontally. If you can mentally "fit" the car into a given geometric shape, try to do without unnecessary lines.
Step 3
The tank can be divided into 3 parts. These are caterpillars, middle and tower. Divide the conditional or drawn rectangle into 3 parts in height. The middle part and the tower are about the same, the caterpillar is somewhat wider. These parts also vary in length. Draw 3 stripes one above the other. Ignore the cannon for now.
Step 4
Draw the caterpillars. Note that this part is shaped more like a trapezoid with rounded corners than an oval. Place the wheels between the tracks. The T-34 tank has 5 wheels located in one line, and the 2 outer ones are slightly higher. This gives the track a trapezoidal shape.
Step 5
The middle part of the T-34 tank also has a trapezoidal shape. The front bevel is approximately 30 ° to the top of the track. The back bevel is at about the same angle, but there is a ledge at the bottom. In the drawing with a pencil, you should not depict unnecessary details, so draw the back bevel with just an uneven line.
Step 6
Draw a tower. You already have a rectangle on top, you just have to round its corners. The top line should also be uneven because this is where the hatch cover and scope are located.
Step 7
Determine the length of the cannon. Please note that the cannon has two parts. The first is short and wide; it adjoins the tower. It is depicted as a square. Draw the trunk itself with two straight lines. Specify some details (for example, the rear of the turret does not adjoin the tank hull tightly, but at a slight angle). Remove extra lines.
