Orchid is an ornamental flowering plant. The beauty of the flowers is so amazing that you want to admire them constantly. Weaving an orchid from beads, you can afford such a pleasure.
It is necessary
beads, wire
Instructions
Step 1
Weave a piece of paper by placing three beads on the wire. Place the middle bead exactly in the middle of the wire. Now pass the ends of the wire into the remaining beads.
Step 2
In the next row, string 5 beads onto one end of the wire. Then pass the other end through them. Add beads in the same way until you get the desired leaf width.
Step 3
Now decrease the number of beads in the row. Make sure that the wire is tightly tightened, otherwise the sheet will not be flat.
Step 4
Weave the middle of the flower. Cast on the wire two dark beads. Place the first one in the middle of the entire wire. Thread the ends through the second bead. In the third row, string 2 beads, in the fourth - 4.
Step 5
Type two dark beads in the fifth row. Then take two beads of a light shade, and then again - 2 dark ones. At the beginning of the fifth row, cast on 3 dark beads, the next - 3 light and string again 3 dark beads.
Step 6
In the sixth row there are two dark beads, in the seventh - one. Start the next petal: string 1 light bead, 4 dark beads and 1 light. Leave two dark beads in the middle, pass the ends of the wire through 1 dark and 1 light bead.
Step 7
Leave two dark-colored beads in the middle, pass the wire through 1 light and 1 dark bead. The third row contains 2 dark, 3 light and 2 dark beads.
Step 8
Cast on the fourth row from 1 dark, 2 light and 1 more dark beads. Make two of these petals.
Step 9
To form the core of an orchid, take a large bead and pass the ends of the three petals that remain on each of them into its hole.
Step 10
For the second part of the flower, weave three narrow petals and two wide ones. Weave from the end so that the ends of the petals at the end of the weave remain at the base of the petals.
Step 11
Twist the five finished petals together, straighten them alternately wide and narrow. Insert the middle into the second part of the orchid. Twist the ends of the wire.
Step 12
Make a stem. To do this, screw a flower onto a thick wire. Wrap the stem with a thin wire with green beads strung on it.
