A knitted product will acquire individuality if you decorate it with additional accessories: embroidery, applique or an original fur pom-pom made by yourself. And it will not be difficult to choose the necessary material that matches the color scheme of the main product. A little imagination and perseverance, and an exclusive headpiece will appear in the wardrobe.
It is necessary
- - fur
- - round pattern
- - chalk or water marker
- - scissors and blade
- - a needle of medium length
- - threads
- - lace
- - filler for the product
Instructions
Step 1
Place the selected blank, fur side down, on the table top. Any fur can be used.
Step 2
On top of the fur, put a prepared round-shaped template, or a pre-prepared template. In the form of a template, you can use what has the shape of a circle and is usually "at hand" for every housewife - a cup, a jar, a saucer.
Step 3
Press the workpieces firmly to the table and trace along the contour. Cut out the resulting circle with scissors or a razor blade. If the edges are uneven, you don't need to align them.
Step 4
Gently sew on the lace, positioning it from the center to the edge, hooking only the flesh with the needle. The thread should run inside the fur so that no stitches can be seen. With the first stitches, secure the thread to the base of the fur without a knot, (double pull-stitch). This will allow you not to pull out the thread when tightening, since an ordinary knot on the thread without fastening will simply slip through the place where the needle was punctured.
Step 5
Begin sewing 0.5 cm back from the edge. Pin up the fur using the beading technique. Insert the needle from the inside out, while leaving the fur blank on the working needle and support the fur with your index finger. Make the next puncture from the wrong side. And so on until the screed begins.
Step 6
Remove the pom-pom blank from the needle gradually, the needle, at the same time, do not pull at once, you should get a kind of curls.
Step 7
When you reach the beginning, remove the thread with a needle and pull it together. Do this without jerking or jerking so as not to damage the fur or ruin the product.
Step 8
Fill the future pompom with pieces of padding polyester, cotton wool or other filler. Pull the hole and make a double knot seam.
Step 9
Without cutting the thread, start sewing. Sewing, pull up the opposite sides, piercing with the needle crosswise. Reduce the hole until only the lace is left in it.
Step 10
The fur pompom is ready. Attach it to the product at the intended location.
