Little women of fashion, like all adult women, love all kinds of jewelry. Therefore, they will surely like the "Satin bow" hair clip, which can be easily made with your own hands.
It is necessary
- - wide, medium and narrow satin ribbons;
- - flat base for hair clips;
- - scissors;
- - double sided tape;
- - threads;
- - glue gun;
- - brooch;
- - scissors.
Instructions
Step 1
Cut off a piece from a wide satin ribbon that will be 2 times the size of the future bow. Then, two narrow strips should be cut from the double-sided tape. We glue them to the edges of the tape, after which we close it into a ring. In the same way, we make another ring from a wide ribbon.
Step 2
Then we take the two obtained rings and put one on top of the other so that at least one and a half centimeters remains between them on the side. The places where the rings are held together must certainly be in the middle of the bow.
Step 3
We take the thread and use it to fix the satin ribbon rings exactly in the middle.
Step 4
Next, a medium-width tape is used. Cut off a strip from it. It must be bent so that it forms a loop, the ends of which are crossed at an angle of 90 degrees. The inner side of the resulting loop must be pressed to the intersection of the ends of the satin ribbon and fixed exactly in the middle with a thread.
Step 5
Now you need to connect the bows from the wide and medium ribbons to each other, and then glue them with a glue gun.
Step 6
Cut a small strip from a narrow satin ribbon. We will use it to close and decorate the center of the bow. This ring can be fixed with a glue gun or sewn with a thread from the wrong side.
Step 7
We decorate the hairpin. To do this, it is necessary to cut a strip from a narrow satin ribbon, which is exactly twice as long as the base of the hairpin. We glue the tape on the tape.
Step 8
We begin to paste over the hair clip from the inside, and then move on to the outside. Remember that on the outside you need to paste over not only the hairpin itself, but also all its grooves and bends.
Step 9
It remains only to glue the hairpin to our craft. We do this with a glue gun. The "Satin Bow" hairpin is ready!
