Ring fishing is more suitable for deep waters where there is at least a little current. This is an old tried and tested method for those who decide to catch carp or bream.
Instructions
Step 1
It is believed that this type of fishing was invented in Florence. Therefore, sometimes fishing on the ring is also called "Florentine". A rubber boat is best suited for this type of fishing. It will make less noise than a plastic or aluminum boat. It is necessary to equip it with two anchors. One is located at the stern, the other at the bow. This is due to the fact that the boat must stand across the current. Both anchors must be reasonably stable, but can be easily removed from them. If the boat is in the direction of the current, you can get by with one anchor.
Step 2
The ropes of the anchors must be long enough. This will also keep the boat in a stable position when the current is fast. The role of one of the anchors can be played by a purse with complementary foods in the form of porridge, oats or worms. The wallet is a mesh bag with small holes. Weighted with a load, it is thrown into the water on a fishing line or twine. When fishing for bream, different flavors are often used. Artificial or natural (garlic, dill, thyme).
Step 3
When fishing from a boat, it is most convenient to use a short rod. Its optimal length is from 70 to 100 cm. It is advisable to equip it with a powerful nod. It is best if the rod is made of a spring. It is advisable to choose an inertial coil. You can build such a structure yourself. Any fiberglass rod is suitable for this.
Step 4
A plastic container is often fitted under the feeder. A mesh netting with a load will also do. The feeder should not float from the bottom. A tightly stretched fishing line with a thickness of 1 meter or more is attached to it. Holes in the feeder can be made with a soldering iron or drill. It is best to make them with a diameter of 5 to 7 mm.
Step 5
To start fishing, you need to anchor on both anchors. The ring must be securely attached to the line, which is best wound onto a reel. This will avoid confusion. Fishing line 0.3-0.5 mm thick will do. The ring must be passed through the free end of the cord. The lure purse cord must be firmly attached.
Step 6
The pre-prepared bait must be hooked onto the hook. The ring should sink almost to the very bottom. The line tension should be easy to adjust. A cut is sometimes made in the ring. It is easier to start the line from the feeder through it. The ring itself is most often lead. Approximately 50-60 mm in diameter. The ring can be made both removable and non-removable. The bait is delivered down the line by means of a ring. In the same way, the catch rises through the ring.
