How To Make A Hookah From Improvised Means

Table of contents:

How To Make A Hookah From Improvised Means
How To Make A Hookah From Improvised Means

Video: How To Make A Hookah From Improvised Means

Video: How To Make A Hookah From Improvised Means
Video: How to make a homemade hookah 2024, December
Anonim

Hookah smoking has become so popular in our country in recent years that it is offered in almost every restaurant. But a good hookah for home use is quite expensive. You can try to make such a device yourself from the means that are always at hand.

How to make a hookah from improvised means
How to make a hookah from improvised means

It is necessary

  • -metal kettle;
  • -shower hose;
  • -steel tube;
  • - burner;
  • -metal strainer;
  • -soldering rod;
  • -file;
  • -insulating tape;
  • -foil.

Instructions

Step 1

Take the most ordinary metal teapot - it can be successfully used as a flask. Try replacing your smoking hose with a simple shower hose. However, in stores you can also buy a special hose for a hookah, and it is very cheap.

Step 2

To make a device shaft, take a thirty-centimeter steel pipe, a gas stove burner, and an ordinary metal strainer, which you buy for installation in the kitchen sink. Also take a soldering rod to join the metal surfaces together.

Step 3

Take the pipe and burner and try to connect them together so that everything is as tight as possible. Attach the other end of the tube to the lid of the teapot in the same way. Remove the handle from the lid, drill this hole to such an extent that its diameter is equal to the diameter of the tube.

Step 4

Make two grooves on the tube for the solder, and then push it into the kettle at a fairly low height. Place the cover back and solder the ends of the tube to it. After that, the whole procedure is repeated, but only from the back of the lid. After finishing work, grind the seam thoroughly with a file.

Step 5

Next, attach a shower hose or a hookah hose to the spout of the kettle. Obviously, for this you have to saw off the end of the spout. This makes it much easier to push the hose inside. To seal the connection between the hose and the kettle, carefully wrap it with insulating tape. Pull a suitable metal nut onto the spout from above.

Step 6

To seal the place where the lid rests on the kettle, cover it carefully with foil. After that, put a funnel made of foil into the hotplate. Tobacco will be poured there. Place a strainer on top of the hotplate. The hookah is ready - try to smoke it.

Recommended: