A short-stroke yoke is a part of the car that helps to reduce the longitudinal travel of the lever responsible for gear shifting. The transverse stroke reduces the hinge. As a result, backlash disappears in the wings, and the clarity of gear shifting also increases. You can make a short-stroke wings for a VAZ car yourself, but first you should talk about it in more detail.
Instructions
Step 1
If we compare the short-stroke yoke with its standard "sister", the main advantage of the former is that it helps to reduce the travel of the gear lever for engaging / disengaging gears. In addition, the vehicle's gear changes are clearer. This design also has disadvantages. The disadvantages of the short-stroke stage are its high cost, as well as the increased effort when shifting gears.
Step 2
That is why it is advantageous to make such a part yourself. There are quite a few options for short-stroke wings for VAZ cars. The variant described below is simple enough to reproduce. Of course, before making the backstage, you should think about whether you need it. If everything suits you in the process of shifting, if you do not want the lever travel to be more "stiff", then you should not get down to work.
Step 3
So, in order to independently make a short-stroke slide based on the standard one, raise the attachment point of the tube that goes from the gearbox to the lever in the interior of your car.
Step 4
The first step is to disassemble the gear lever. Next, use a grinder to cut off the attachment point of the gear lever from its lower component. Then weld the arm extension and tube between the arm and the bottom of the arm.
Step 5
At this point, the place for attaching the updated wings can be considered prepared. Next, you need to extend the tube that comes from the gearbox. This procedure is usually performed next to the car. Why, you ask? Yes, because you will have to cut and try on the part several times to its place.
Step 6
The next step begins by cutting the tube from the checkpoint. You need to cut it at the point where it bends and then goes into the body of the car (there is an elastic band on it).
Step 7
At the final stage of manufacturing a short-stroke backstage for a VAZ car, screw one end of the tube to the gearbox handle. Next, see how much you still lack, and then weld the adapter. This concludes your work. Of course, in one of the tuning centers you would have made a backstage in no time. However, it is more interesting and cheaper to repair and improve your car yourself.
