To create jewelry with your own hands, you need to have imagination and have the necessary materials. If you can't think of exactly how to do it, take the diagrams and descriptions of the process. One of the simplest pieces of jewelry that you can make yourself is a bracelet.
It is necessary
- - lace;
- - a needle;
- - thread;
- - beads;
- - large decoration;
- - rubber;
- - glue;
- - plastic bottle;
- - denim;
- - beads;
- - pins;
- - wire;
- - a lock for jewelry.
Instructions
Step 1
Take two identical laces. Their length should be about a meter. Tie them in a tight knot on one side. Take a needle and thick thread. Secure the end of the thread near the knot. Wrap the thread around one of the laces twice. Place a large bead on the string. Now wind the thread around the other lace.
Step 2
Put the bead back on the string and pull it to the other string. Continue this way until the end of the laces. An even row of beads should appear between them. Keep the thread taut at all times. Tie the end of the string and laces together. You will end up with a long ribbon.
Step 3
Pick up a small bow or flower. In color, it should be in harmony with the beads. Attach a thick elastic band on the back. Cut off the ends at the laces. Glue their knots together. Put on the jewelry on top and go over with glue again. The bracelet is ready. To wear it, you need to wrap it around your hand several times. A similar model can be created from short laces. Then the ends do not need to be glued, but connected with a clasp.
Step 4
Take a plastic bottle. Cut a wide bracelet out of it. Prepare thick denim. Cut it so that it is slightly wider and longer than the bottle blank.
Step 5
Embroider any pattern on the fabric with beads or sew along the edges along a row of large beads. Place the fabric on the bottle blank and glue it down. The bracelet is ready.
Step 6
Take the pins. String small beads on them until they are completely filled. Smear the sharp tip with glue and close so that the pin no longer opens.
Step 7
Prepare a thin wire or thick elastic band. Cut it into two equal pieces - their length should be slightly longer than the length of the arm. Place all pins (the same side) over one piece of wire or elastic. Insert the second piece into the other part of the pin (i.e. they will be strung on two pieces of wire / elastic from different sides).
Step 8
If you used wire, tie the top end to the bottom end into a knot. Put on a small clasp that will connect the wire. If you used an elastic band, simply tie all the ends into one knot and cut off the unnecessary parts.
