DIY paper is very different from machine made paper. Its performance properties are much lower. The paper turns out to be uneven in thickness and consistency, most often it is not suitable for printing, but it has an undeniable advantage - it is uniqueness. No matter how hard you try, you cannot get two identical sheets, which means that hand-made paper is in some way exclusive.
It is necessary
- - the cloth;
- - paper;
- - mesh screen;
- - newspapers;
- - water;
- - sponge.
Instructions
Step 1
First, you need to make a screen for paper; to save time, a ready-made screen can be purchased at do-it-yourself stores. Look for a suitable metal mesh with a mesh width of 1.5 to 2 cm and a mesh with a smaller mesh. The smaller the grid cell, the better. It is possible to use a mosquito net. Cut two identical pieces of metal and mosquito netting to the size you want. Lay the fine mesh on top of the metal mesh and line up the edges. Tape the entire mesh around the edges with duct tape.
Step 2
You will need to turn the scraps of paper into pulp. A regular kitchen blender works well for this. Fill a bowl with warm water: just over half its volume. Pull the paper into pieces a couple of centimeters in size. It is not necessary to use paper of the same color; you can also make colored, so-called design paper. Once you've prepared the right amount of paper, turn on the blender and start adding paper gradually until you achieve a homogeneous pulp.
Step 3
Take a wide container, a regular basin will do, and pour in the contents of the blender. If the mass is too thick, then dilute it with warm water and mix thoroughly. Check if cellulose collects on the screen by dipping it halfway into the solution. If the mass adheres well to the screen, immerse the screen several times. Distribute the mass evenly over the surface of the net by shaking the screen. Tilt the screen to allow the water to drain.
Step 4
Spread the fabric on a flat surface and flip the screen over onto it. Gently blot the back with a sponge to remove excess moisture. Separate the screen from the pulp. If the screen has moved away, then cover the resulting paper with newspaper and cloth and send it under the press. Press down the product with any flat surface. Carefully peel the paper away from the fabric and let dry.
