How To Make Flowers From Balloons

Table of contents:

How To Make Flowers From Balloons
How To Make Flowers From Balloons

Video: How To Make Flowers From Balloons

Video: How To Make Flowers From Balloons
Video: Two Balloon Flower - Balloon Animal Lessons #6 ( globoflexia ) 2024, December
Anonim

A flower from balloons or a whole bunch of them is a wonderful gift, a sign of attention, as well as a simple, quick and inexpensive way to decorate any room for the holiday. There are several ways to make these flowers, as well as their varieties. Basically, for the construction of such a composition, round balls and balls for modeling are used, from which it is easier and most natural to make flower stems.

How to make flowers from balloons
How to make flowers from balloons

It is necessary

  • - hand pump;
  • - multicolored latex balloons (5 "diameter);
  • - green balls for modeling (SHDM);
  • - sizer (cardboard template).

Instructions

Step 1

Choose four five-inch beads of the same color for each flower. Using a hand pump, inflate them with air and tie the ends in a knot. These will be the petals of the flower.

Step 2

Tie the tails of two balls of the same color in a knot to form the so-called "two". Make two “twos” for each flower, and then weave them together in “fours”. Weaving is done by wrapping the tied tails of one "two" of the tails of the other. The flower petals are ready.

Step 3

Make the “center” of the flower: inflate a yellow five-inch balloon to about three times the diameter of the “petals”. Tie its tied tail to the knots of the "flower" itself and thread the "middle" into the center, between the "petals".

Step 4

Craft a flower stem. Pump the long green modeling balloon. It is very important that it has an empty tip of about eight centimeters. Next, make "leaves" on the stem: for this, perform the manipulations that are schematically shown in the figure attached to this step

Step 5

Tie the stem with leaves to the head of the flower, tying their tails together. Thoroughly straighten and twist the "petals" and "leaves", carefully placing them relative to each other. Give the stem a more natural curve. The balloon flower is ready!

Step 6

An interesting version of such a flower can be a product, the petals of which are curly balls in the shape of a heart. Also, you can make a flower not with four, but with seven or eight petals - instead of the "middle" place inside the first "four" one more, but from balls of smaller diameter. Moreover, all the petals can be of different colors.

Recommended: