When embroidering, it is necessary to fasten the thread, but such a knot as in sewing is unacceptable for embroidery. Knots can deform the fabric, stretch it, or make it bumpy. When sewing stitches, the threads can cling to knots, and you will no longer have the opportunity to dissolve an incorrectly made pattern. The end of the thread must be fastened at the beginning of the work and as the thread ends. Experienced craftswomen have several ways to secure the thread.
It is necessary
- - embroidery needle;
- - threads;
- - embroidery hoop.
Instructions
Step 1
Loop method. Suitable if an even number of threads are involved in the work. For example, when working with twofold thread, cut the single thread twice as long as you would normally use. Fold it in half and thread the two cut ends into the eye of the needle. At the opposite end of the thread, you will get a loop. Stick in the needle from the wrong side and pull the thread so that the loop remains on the wrong side. Pierce the fabric from the right side and thread the needle through the loop on the wrong side. Pull up the thread. The result is a setting.
Step 2
When working with an odd number of threads, you can use the "no knot" method. Insert a needle 1 to 2 cm into the fabric from the beginning. Leave the ponytail loose. When starting to embroider, make sure that the stitches (crosses) overlap the loose thread. After the stitches have been sewn, simply cut off the remaining tip. The stitches will hold the end of the thread securely.
Step 3
Method "with a knot". This method differs from the one described above only in that a temporary knot is tied at the end of the thread. It prevents the thread from escaping with a sharp movement of the embroiderer's hand. After the tail is fixed, be sure to untie the knot. Make sure that the knot is not under the stitches.
Step 4
With an odd number of threads, you can secure the tip by making a few small stitches on the canvas, which will then overlap with the main pattern. Make the stitches small and cover them with the same color thread.
Step 5
If the stitches do not cover the end of the thread or you forget about it, you can secure the thread by passing it on the wrong side under the stitches that have already been sewn. The ponytail should go under at least five crosses. If the thread is slippery and runs out of the stitches, you can loop it around the second or third stitch.
Step 6
Once the thread is secured, cut all the ends that come out tightly to the fabric. This will prevent the seamy side from fluffing like a terry towel towards the end of the embroidery. Also, the shaggy ends will not come out to the front side when the needle is poked out next to them.
