How To Make A House For A Well Yourself

Table of contents:

How To Make A House For A Well Yourself
How To Make A House For A Well Yourself

Video: How To Make A House For A Well Yourself

Video: How To Make A House For A Well Yourself
Video: DIY build your own backyard well for free water 2024, December
Anonim

Despite the fact that a person's lifestyle has changed a lot, wells remain popular to this day. They are installed in dachas and villages so that they can collect water for drinking and cooking. No less popular is the well house. In addition to keeping dust and dirt from getting inside, it prevents water from freezing in winter.

How to make a house for a well yourself
How to make a house for a well yourself

It is necessary

boards, beams, racks, nails, screws, hinges

Instructions

Step 1

Making a house for a well should start with preparing the material. The boards must be trimmed and adjusted to the desired size. In addition, the earth is leveled around the well and crushed stone is tamped.

Step 2

Make a frame. To do this, take a bar with a section of 100x80 and an edged board, the thickness of which is 40 mm. You will also need four 80 mm racks and four 120 mm edged boards. They will be used for the top and bottom strapping.

Step 3

Place two frame posts on a flat surface. Nail boards to them, the length of which has been determined in advance. Connect the other two frame posts together. Next, connect the front and back walls with boards.

Step 4

The next step is to install the roof and frame sheathing. Cut the rafters into a bevel and connect at the top. Then lay them on the ground, connect at the top and fasten with self-tapping screws. Pin the deadbolt to prevent divergence.

Step 5

In the places where the rafters touch the board, make an incision, then pin the trusses to the harness. For fastening, use nails 120 mm long. Trusses can be strengthened with jibs.

Step 6

Use planks when joining trusses. Cover the roof with roofing material on top. Cover the frame with slate. Cover the corner joints of the cladding with wind boards.

Step 7

Craft a door. To do this, lay out the boards, and on top of the bars. Use self-tapping screws to fasten them together. To prevent the door from warping during operation, an additional bar must be fixed between the connecting beams. It will add rigidity to the structure.

Step 8

Boards that are between the boards located on the sides must have a tight end connection. Therefore, the bars must be attached to them.

Step 9

Install the door to the house using the piano hinges. In this case, on the one hand, the hinges are attached to the door, on the other, to the gable trim.

Recommended: