You can try to make a model of the church from different materials. However, it will be difficult for non-professionals to make a model of such an architecturally complex building. Therefore, it is best to use the most ordinary matches to build the layout of the temple.
Instructions
Step 1
First, stock up on matches: you will need a lot of them for a full-fledged model of the temple. Before starting the actual creation of the small church, make 22 match cubes.
Step 2
To make a cube, put two matches in parallel, while the distance between them should be slightly less than the length of the match. Place eight matches perpendicular to them. Next, eight more matches across to make a lattice. Put two matches along its edges: two - from below, two - from above in parallel. So make eight rows high. Then place eight matches in the same way as in the base of the product. Place six matches in the middle and secure the cube with a coin placed on top. Insert four matches vertically at the corners of the cube. Squeeze the structure to make it stronger.
Step 3
When the base is prepared, insert the matches on the side of each matchbox so that they are along the third row. At the same time, arrange them in ascending order and break off their excess length. Place the matches across the cube in the same way, keeping in mind the same progression (i.e. 3, 6, 10).
Step 4
After that, tighten the side matches and press them with another row of inserted matches. To make the part more dense, squeeze the matches. After compression, the part will turn out with a part of the roof. Make four such details, and two should "look" in the other direction.
Step 5
Connect the roof parts with other parts. Next, connect the three cubes in height. Connect the first workpiece with matches and insert the three cubes that you connected earlier into the middle of the structure. Squeeze the top to complete the roof in two cubes.
Step 6
Connect the two cubes on which you made the roof with those cubes that are located below, as well as with each other. Next, make two more cubes with a roof and attach them a little higher. Now attach another one from the bottom to each cube. Connect the two columns together as well as the others. It turned out the frame of the temple.
Step 7
Build two more towers of two cubes with a roof at the top. Form on both sides of the window, lining them with match heads. Push the towers forward a little and attach them to the edges of the church. Proceed in the same way on the back of the temple. Next, mount an ordinary house in the back of the church. To do this, stick the matches not completely and secure the house with their help.
Step 8
You can decorate the temple, add a chapel, or hang a bell there.
