Fishing is almost an art, it is a lifestyle and a special attitude towards it. Fishermen, who truly appreciate the moment, spare no effort and time not only for the fishing process, but also for the knowledge of both nature as a whole and the habits and characteristics of its individual inhabitants. Therefore, in the business of preparing tackle for them, there are no trifles. Every detail of every tackle is very important. For example, the correct choice and method of tying the front sight.
It is necessary
small watch vice, hook, feather
Instructions
Step 1
How to make a fly - a moth. Bend hook number 6 or 8 with a long forend in the middle, with a sting down. Use a vise when doing this. Fasten a silk or floss thread, starting from the middle, without reaching the loop of 1, 5 or 1 mm.
Step 2
Under the first coils, place awns from a large feather, moreover, a flywheel, and even white. But first wipe it with a sandpaper. If there is no feather, you can take the hair of the animal. If you need to make a fly in a "wet" form, then saturate the white threads with glue.
Step 3
Take glue BF - 2. From a piece of white feather, make the villi - frill. Tie these villi with a pale yellow or yellow-green thread. You do not need to cut the threads, make the head of the front sight out of them. Glue two white small feathers on the sides and tie with a thread. Tie them at an angle of 60-80 degrees to your body.
Step 4
A moth or moth is made on a hook number 5 or 8, with a medium-length forend. Again, use forged, nickel-plated hooks. Wrap gray or brown threads on the hook, glue them with glue.
Step 5
Pick up a fluffy, light brown thread and wind it tightly, as if making the belly of a moth or moth. Make a head about 2 mm in size from brown floss threads. Tie the wings with the same thread. The color of the wings and body is the same. If there is no colored feather, then paint white. This is how you can make the simplest flies.
Step 6
To tie the front sight to the leash, use a gripping knot. Take the end of the line and pass it through the ring on the lure hook. Then make 4-3 turns with the ring of the carabiner, and put the end of the line between its turns and the ring at the carabiner.
Step 7
Pull the main line and its end in different directions, thus tightening the resulting knot. This knot reduces line breakage. Happy fishing!
