How To Knit A Bolero

Table of contents:

How To Knit A Bolero
How To Knit A Bolero

Video: How To Knit A Bolero

Video: How To Knit A Bolero
Video: How to Knit Bolero Jacket Pattern #629│by ThePatternFamily 2024, December
Anonim

The ballero is knitted in straight and reverse rows with a pearl pattern on circular knitting needles, then raise the loop detail along the edge and knit an elastic band in a circle.

How to knit a bolero
How to knit a bolero

It is necessary

400-600 g of yarn (100% wool, 75 m / 50 g); circular needles No. 5 (80 cm); circular needles No. 4, 5 (80 cm) for elastic

Instructions

Step 1

Cast on circular knitting needles No. 5 122-142 sts (including 1 edge loop on each side), Tie 3 rows of LP, at the same time, evenly subtract 24 loops in the 3rd row (knitting together the LP together about every 5th and 6 p.) 98-118 p.

How to knit a bolero
How to knit a bolero

Step 2

Continue distributing the stitches as follows: 3 sts in garter stitch, pearl stitch until the last 3 sts, 3 sts in garter stitch.

At a height of 8-13 cm, cast on 12 new loops on each side for sleeves 122-142 loops. At the same time, continue to carry out the pearl pattern on all loops, except for 3 on each side, which are knitted with garter stitch. Mark with a thread of a contrasting color at a height of 26-36 cm and then measure the part from here. At a height of 44-59 cm, close on 12 loops on both sides of 98-118 loops.

How to knit a bolero
How to knit a bolero

Step 3

Continue to carry out the pearl pattern on all loops except 3 on each side, which must be knitted with garter stitch, up to a height of 52-72 cm (the last row of the PI should be knit). Then tie 3 rows of LP, at the same time add 24 loops evenly in the 1st row 122-142 loops. Go to circular needles N. 4, 5, pick up 122-142 loops along the typesetting edge of 244-284 loops, and then knit in a circle on all loops. Tie PI 1 round row, adding evenly 60-72 loops, (1 loop approximately between every 4th and 5th loops) - see note 304-356 loops, Tie 1 circular row of PL and continue with elastic 2LP / 2IP on all loops, at the height of the elastic band 3 cm, add 1 loop in each section of the elastic band from the PI (performing 2 liters, from the 1st PI) = 380-445 p. And then knit with an elastic band 2 LP / Z PI to a height of b cm. Then add 1 loop in each section of elastic from the PL (doing 2 loops from the last PL) 456-534 loops. And then knit with an elastic band 3 LP / W SP until the height of the elastic is 9 cm. Close the loops according to the pattern.

How to knit a bolero
How to knit a bolero

Step 4

Assembly. Sew shoulder seams. Sew open sections of armholes - see dotted line on pattern.

Recommended: