Foamiran roses are wonderful decorative elements that can be used to create hairpins, headbands, elastic bands and more. If you make a little effort, then roses from this material will turn out to be real.
It is necessary
- - foamiran of pale pink and green colors;
- - wire;
- - cotton pads;
- - brown tape;
- - brush and paints;
- - pen and pencil;
- - scissors;
- - Super glue;
- - iron;
- - green threads;
- - pliers.
Instructions
Step 1
First of all, prepare all the materials for creating the rose.
Step 2
Cut a strip of about five centimeters wide from the pink foamiran along the entire length of the material, then fold it into an accordion no more than five centimeters wide, draw a drop shape on the "Foma" and cut it, affecting all layers of the material.
Step 3
Cut a strip five centimeters wide from the green foamiran, also fold it like an accordion, draw a leaf on the material and cut it off.
Step 4
Using the usual green and pink paint, lightly tint the petals and leaves so that they look more like real ones.
Step 5
Turn on the iron, heat it up, then attach the "petal" to it and as soon as it heats up, try to slightly stretch it to the sides, then gently bend its edges to the wrong side (for this you can use a knitting needle, wind the edge of the petal, warm up and release). Thus, arrange all the other "petals".
Step 6
Place a sheet on the iron, heat it up and twist it between your fingers. Then spread it slightly. Decorate all other leaves in the same way.
Step 7
As a result, you should have about 20 petals, five sepals and 10 leaves.
Step 8
Once the petals, leaves, and sepals are ready, start collecting the rose. Tie a tightly twisted cotton pad to the wire, put a petal from "Foma" on it, wrap a cotton pad with it and glue it.
Step 9
Take the second petal, coat its lower edge with glue and attach it to the base of the flower, then take another petal, in the same way, coat the lower edge with glue and glue it to the base of the flower, but on the other side of the core. In this way, glue all the other petals, trying to place them evenly.
Step 10
Attach the sepals to the base of the finished flower and tie them in with thread.
Step 11
Wrap the base of the flower with a thin foamiran tape. Make a shape in the shape of a cross from the wire, glue the previously made leaves to the three ends of the resulting figure, and then attach the wire itself to the stem of the rose. Wrap tape around the stem of the flower.
Step 12
Follow the above scheme to make a bud and attach it to the stem. A beautiful rose from foamiran is ready.