A vase with an original design will be a wonderful decoration for a table, as well as a living room or bedroom. A bouquet of flowers in such a vase will make the room cozy and attractive.
It is necessary
- - glass vase;
- - PVA glue;
- - cotton threads No. 10;
- - napkin for decoupage;
- - water;
- - a toothpick;
- - spray white paint;
Instructions
Step 1
Cover the vase with spray white paint in the following way: richer at the top (along the rim) and below - where the napkin motifs are expected to be located. And smoothly, with a thin layer, draw the paint over the entire vase, as if slightly powdered. Let the paint dry.
Step 2
Cut the motifs out of a napkin and glue them to the vase with PVA.
Step 3
Cut a thread 15-20 cm long and, holding one end, dip it in water so that it gets well wet. Then in the same way dip the PVA into the glue, remove the excess glue by pulling the thread along the edge of the can.
Step 4
Lay out the curl, holding the end of the thread with 2 fingers of your left hand, and with a toothpick in your right hand, while correcting, help the thread to lie down beautifully.
Step 5
After the entire piece of thread has been laid, walk again with a toothpick and align, correct the pattern. And so continue to "draw" with a thread until you fill the entire area of the vase. Let the curls dry periodically to continue further.
Step 6
Complement the pattern with halves of beads, or in this case, dots are made with a putty through a medical syringe. Cover the vase with spray varnish.
