More and more often, tables and chairs of author's production are in fashion now. It turns out that even an inexperienced craftsman will probably be able to make a table and chairs on his own.
It is necessary
- - laminated chipboard (chipboard),
- - drill,
- - drill,
- - roulette,
- - screwdriver,
- - plywood,
- - wooden blocks,
- - ordinary self-tapping screws,
- - sandpaper of different sizes,
- - screwdriver.
Instructions
Step 1
How do you make a table? You will need material - laminated chipboard (chipboard). First, the chipboard sheet must be cut into 4 component parts and the edges of the resulting parts must be processed. The parts will be fastened with ordinary furniture screws. The necessary tools are a drill, drill, tape measure and screwdriver.
Step 2
First you need to drill holes in the end walls of the table, then drill a groove. Next, you need to attach the sidewall to the end part of the inner wall of the table, drill a recess for the screw and tighten it. Already with the screwed in, a hole should be drilled under the second one and also tightened. The second side of the table must be attached in the same way.
Step 3
The table top is attached in the same way. It will not coincide along the perimeter with the inner and side walls and will protrude beyond them. This release is needed so that the plinth on the floor does not interfere with the tight pressing of the table against the wall, because usually tables are installed in the corner or just against the wall. The size between the back of the table and the lid depends on the size of the skirting board. When the table is fully assembled, the screw heads can be closed with decorative plugs.
Step 4
Now it's worth figuring out how chairs are made. You will need plywood, wooden blocks, ordinary self-tapping screws, a drill, a drill, sandpaper of various sizes and a screwdriver.
Step 5
First you need to make the blanks. Next, the finished parts must be processed with sandpaper. After that, you can start assembling and assemble two side blanks with ordinary self-tapping screws. Next, you need to connect these blanks with bars. After that, the back and seat are installed. The chair should be varnished.
