If you are a fan of all kinds of crafts, then I think you will like this one too. I suggest you make a very unusual creation - transfer your photo to a tree. To be honest, I had a chance to learn about such creativity not very long ago, but it immediately captivated me.
It is necessary
- - board;
- - the photo;
- - laser printer;
- - fine sandpaper;
- - PVA glue;
- - acrylic lacquer;
- - sponge;
- - warm water;
- - acrylic paint.
Instructions
Step 1
So, first you need to enlarge the photo to the required size, and then print it without fail on a laser printer so that you get the opposite image.
Step 2
Now you need to prepare a wooden board to which the image will be transferred. It needs to be processed with sandpaper in order to remove all roughness and irregularities.
Step 3
Then the treated surface of the wooden board must be covered with PVA glue. If this is not the case, then you can use acrylic varnish, but it is still better to use the former.
Step 4
Next, the printed photo must be placed on a wooden board so that the image is at the bottom. The print should be gently smoothed out with a sponge and all the air should be squeezed out. The quality of the craft depends on this procedure, so do everything very carefully, without rushing.
Step 5
After the print has been applied to the wood surface, allow time for it to dry. It dries for about 12 hours.
Step 6
After the time has elapsed, remove the paper from the board with warm water and a sponge. Don't be discouraged if the paper does not come off well with the sponge. In this case, you can simply roll it up with your finger - in this case nothing will happen to the image.
Step 7
As soon as the drawing is dry, it must be covered with acrylic varnish and then allowed to dry completely. The transfer of the photo to the tree is complete!
