If you want to do an unusual kind of creativity - create earrings in a single copy - make them from polymer clay. Then you can decorate your earlobes with roses, lilies of the valley.
Lily of the valley earrings will remind you of spring and early summer. To make them, here's what you need to stock up on:
- toothpicks;
- green and white polymer clay;
- acrylic varnish;
- thin rubber gloves;
- chain;
- thin fishing line;
- with a sharp knife;
- with a brush;
- two split rings;
- mother-of-pearl beads;
- 2 pieces of ear wires;
- with a bulka - a tool at the end of which there is a ball with a diameter of 5-6 mm
- 2 transparent large beads;
- a lighter;
- scissors.
Once everything is at your fingertips, start creating. Cut a piece from white polymer clay, knead it in your hand to make it plastic. Roll a 7 mm sausage out of it. Use a sharp knife to cut several identical pieces from it and roll them into balls.
Slightly flatten the first one, put it on the bulka, roll it. Do this with all the spell balls. In total, you will need 18 pieces. The thickness of their walls should be the same.
To prevent a piece of polymer clay from sticking to the round part of the gourd, turn the blanks over, do not let them stay in one position for a long time.
Pierce each blank in the center with a toothpick, these holes will be needed further, through them you will string flowers from plastic.
You can make them not all white, let 4 blanks imitate unblown buds. To do this, add a drop of green polymer clay to a piece of white plastic blank, mash it well. Make these buds just open a little.
Now you need to select the petals. To do this, press evenly in five places on the edges of the blanks with a toothpick so that petals form between these jams.
When purchasing polymer clay, make sure that it cures with heat, not air.
Put the blanks in an oven preheated to 130 ° C for 15 minutes or dip them in boiling water and boil for 15-20 minutes. Now pierce each bud from the back with a toothpick, drive the other end into the sponge. In this position, it will be convenient to cover the workpieces with acrylic varnish, which you will do. You can apply not 1, but 2-3 layers, when the varnish dries, collect the earrings.
To do this, cut 18 pieces of 10 cm from the fishing line. Divide the flower blanks symmetrically into 2 piles so that both there and there there are 2 green buds. Prepare 2 chains - each with 10 links.
Take the first piece of fishing line, string a bead on it, stretching it to the middle of the fishing line. Fold its 2 edges together, pierce the middle of the smallest bud with them. Now pass the same 2 ends of the fishing line through the second hole in the chain from the top, and then into the last one.
Now take the second piece of line, thread the 2 edges of this line through the next greenish bud, and then into the third hole in the chain from the top. This bud and the first one should be turned back to each other.
So collect both earrings, each time securing the flower with the fishing line, pushing its ends into the next link in the chain. Tighten the edges of the woods a little, align the flowers, cut off so that the ends of the lines become the same length, push them into one large bead. Divide the bundle from the edges of the fishing line by 3, put on 1 bead for each batch. Under them, tie a knot from a bundle of fishing line, cut off the excess, singe the edges with a lighter. Put an earring on each earring, the earrings are ready. You can make rings, tiaras from plastic and have a lot of designer jewelry for all occasions.
