Even those who are used to wearing short hair sometimes want to change their style and get a lush high hairdo. In this situation, a chignon will help out. It can be made in such a way that even the keenest eye cannot distinguish false hair from your own. Chignon can be bought at the store or weaved. In both cases, it is very important to choose the hair so that it fully matches yours, not only in color, but also in structure.
It is necessary
- - long natural hair;
- - 2 racks;
- - a simple wooden table;
- - nylon threads according to hair color;
- - metal pin;
- - 3 guitar tuners:
- - ruler:
- - pencil;
- - 3 coils;
- - hand drill;
- - a bowl of water;
- - a round disc with a diameter of 5-6 cm;
- - thick needle.
Instructions
Step 1
Make a Tresbank. Attach 2 uprights to the table, 65-70 cm apart. Racks can be removable. In this case, the edge of the table is simply clamped with clamps. If nothing suitable is at hand, just nail the slats to the table at the same distance. They must stand strictly upright.
Step 2
Measure 5-7 cm from the top of the left pillar and make a mark. The first peg will be here. The second must be attached strictly under the first, and the third - under the second. The spacing between the tuning pegs is equal to the distance between the top of the rack and the top. On the right upright, mark the location for the pin. It should be directly opposite the middle peg. Attach all required details. For the tuning pegs, the most convenient way is to make holes.
Step 3
If the nylon threads are wound on one large spool, rewind them on 3 small ones. For a chignon, each thread should be at least 6 m. Put the spools on the pegs. Fix them so that the winding direction is the same. Pull the loose ends of the threads between the pegs and the pin and tie into a knot between the posts, about 5 cm from the right.
Step 4
To start weaving tres, take a strand of 10-20 long hairs. Moisten it with water. Draw the end of the strand next to the knot away from you over the bobbin thread, loop over the middle and top strand together, and pull the end towards you over the top thread. Pass it from you between the upper and middle threads and bring it out to you in the gap between the middle and lower threads. Tighten the strand, slide it towards the knot and press firmly. It is most convenient to push the knots towards each other with a needle. You have got 2 strands, different in length. The short end should not be shorter than 4 cm. Weave the rest of the strands in the same way. Make sure they are tightly pressed against each other.
Step 5
The truss for the chignon is quite long. It must be sewn. This is done in a circle. First make a ring by wrapping the end of the thread around the blank. The hole is needed to put the chignon on your own hair, tied in a ponytail. Then sew in a circle, trying to fasten the turns as evenly as possible. The circle should be flat.