A cannon is a type of artillery weapon. In past centuries, this weapon was used quite often. It was also installed on ships, where it was simply irreplaceable. But how do you draw such a weapon?
It is necessary
- - album sheet;
- - pencil;
- - eraser.
Instructions
Step 1
Draw general sketches of the cannon. First, in the middle of the sheet, draw a long, narrow oval diagonally with the left edge up. This will be the muzzle of the gun. Draw a straight line parallel to the oval at some distance under it.
Step 2
Connect the line to the muzzle with smooth lines at both ends of a straight line. Thus, depict a gun carriage - a stand for weapons. Attach the visible wheels - draw the circles so that the bottom border of the carriage would cut them almost in half.
Step 3
Draw the details of the muzzle of the cannon. Tighten the top end slightly and widen the bottom end a little. In the wide part, draw the butt - draw a circle, half of which is the extreme border of the oval. Now attach the implement handle.
Step 4
Draw rings that are placed in several places on the muzzle of the weapon. Draw curved lines, with their bulges facing the upper end of the barrel and extending beyond the oval. Draw a spot for the wick. Draw a small circle around the top of the muzzle.
Step 5
Draw the details of the carriage. Draw the top and side border of the visible wall with a double line, symbolizing the thickness of the board. At the top, draw two bolts - small ovals separated by curved lines for 3D. Draw the continuation of the attachment.
Step 6
Draw the bottom of the carriage: to the extreme part of the side wall, draw a line located almost at a right angle to it. Again, depict the thickness of the board by drawing a second straight line parallel to the first. Go over all visible parts of the carriage with short strokes to give the appearance of the wood structure.
Step 7
Draw the details of the wheels. Draw ovals that run diagonally in the same direction as the tilt of the cannon. Separate them with raised lines separating the visible side from the top, which is an indication of the thickness of the wheel. Draw the mountings in the middle of the wheels.
Step 8
Draw the details of the cannon. Draw the supports for the wheels, first depicting them as a cube. Also draw the cannonballs - small circles, the diameter of which should not exceed the size of the thinnest part of the muzzle.
