Combine harvester - a machine that simultaneously cuts ears, separates the wheat from the chaff and pours the wheat onto a nearby truck. Such a mechanism consists of many parts assembled in a specific order. How to draw a harvester?
It is necessary
- - album sheet;
- - pencil;
- - eraser.
Instructions
Step 1
Sketch the general outlines of the harvester with a pencil. Draw a small rectangle in the middle of the sheet. Draw another one above it, the long side of which is two times shorter than the original shape. This will be the main body of the machine with the cockpit attached.
Step 2
In the lower left corner of the large rectangle draw a circle - the front wheel, in the lower right corner draw a circle with a smaller diameter - the rear wheel. Draw a straight line at an angle to the main body of the combine. This section will symbolize the header - the front of the machine.
Step 3
Connect the center of the header line to the combine body with a straight piece. Attach a stacker to the back - depict it as a shapeless circle.
Step 4
Draw the details of the main body of the combine. Divide the rectangle in half horizontally. The lower part will be a thresher. Cut corners at the wheel locations. Please note that the thresher must extend well beyond the rear wheel. Draw the stairs.
Step 5
Draw a pipe through which the grain is poured. Now draw the glass of the cockpit. On the right side of the cab is the engine. Draw the visible part of it in the form of a small shaded area, clearly highlighting the small circle and pipes - one wide and the other narrow curved.
Step 6
There is a bunker in the background behind the cockpit - draw an inverted cube. Draw the wheels of the combine. Draw the outer border of the front with a jagged circle. Draw the disks with several strokes repeating the line of the wheels.
Step 7
Draw the details of the header. Draw regular pentagons on both sides of the original line. Draw rays from each corner to the middle. Now connect each corners of the shapes in pairs with straight wide lines with jagged edges. Also connect the midpoints of the pentagons.
Step 8
Draw the attachment to the cutter bar above the header. Draw it with small triangles located directly under the header drum. Draw the feeder chamber with two parallel lines.
Step 9
Draw a stacker. Draw its upper part with a lattice, and the lower one in the form of two large main plates.
