How To Assemble An Origami Swan

Table of contents:

How To Assemble An Origami Swan
How To Assemble An Origami Swan

Video: How To Assemble An Origami Swan

Video: How To Assemble An Origami Swan
Video: How to Make an Origami Swan (Intermediate) - Rob's World 2024, December
Anonim

Origami Swan is a simple and effective classic Japanese model. It can be done in a few minutes. A beautiful swan is perfect for a cute romantic gift. Start mastering origami with this model. Even if this is your only creation, you will not regret the time spent.

How to assemble an origami swan
How to assemble an origami swan

It is necessary

  • - a square sheet of paper;
  • - a coin.

Instructions

Step 1

Take a clean, square piece of paper. Fold in half, and run along the fold with your fingernail or a coin to keep the fold from flattening.

Step 2

Turn the sheet over to the other side.

Step 3

Bend the two edges so that they are located along the fold line, which was formed at the very beginning. Leave a small gap. Do everything so that the X corner is sharp.

Step 4

Fold the top and bottom sloped edges inward towards the center fold.

Step 5

Fold the workpiece in half, flatten it firmly.

Step 6

For the neck, bend the pointed end to the right so that it is parallel to the tail line and flatten firmly.

Step 7

Straighten your neck.

Step 8

Smooth the swan slightly to separate the bottom edges. Turn your neck inside out.

Step 9

Make a fold at the top of the neck.

Step 10

Unfold the fold.

Step 11

Turn the top tip inside out using the folds made in step nine.

Step 12

Press down and press down on the folds made in steps 5, 6, and 9.

Step 13

Start making the beak. Bend the top of the top tip first. Use the folds made in step nine as a guide.

Step 14

Make a small fold and repeat folds 5, 6, and 9.

Step 15

Peel back the tip.

Step 16

Smooth out the crease.

Step 17

The origami swan should look something like the picture. To complete it, make two more small folds.

Step 18

Take the swan by the head with your right hand, with your left hand clamp the front of the head with the beak. Now gently lower your left hand down to a small angle. The top edge of the head should snap at the point indicated by the arrow, and the layers of paper that make up the head should be bent.

Step 19

If the previous steps were performed correctly, then it should look like in the picture.

Step 20

The swan is almost ready. Refine the tail for a more natural look.

Recommended: