A mobile phone is an essential attribute of a modern person. Almost every resident of the country has at least one mobile phone, and in large families there can be almost a dozen of them! Often the wires from the phones get confused with each other and underfoot, they can be touched, which will entail an unwanted fall of an expensive "trick". To keep your phone in perfect order, as well as quickly identify your own among several identical ones, make a convenient stand for it, in which you can hide the wires.
It is necessary
- - a plastic container of a flat shape from under any cosmetic product;
- - marker, scissors, stationery knife;
- - PVA glue;
- - beautiful fabric.
Instructions
Step 1
Choose from the empty plastic bottles and vials available in the home that is the flatter and most suitable size for your cell phone. Wash it well with hot water and dry it.
Step 2
Place the phone against the bottle, placing their bottom planes on the same level. Mark with a marker on the bottle the height of the stand that you think is most comfortable. Draw a horizontal or any curly line on the front of the bottle and continue on the sides.
Step 3
Turn the bottle and draw a holder on the back of it, for which you can hang your mobile phone directly on the "plug" of the charger during recharging. Make a holder with a large hole in the shape and size of the "fork" so that it fits freely into it.
Step 4
Use scissors or a utility knife to cut the stand along the outline. It is more convenient to cut a hole in the holder on a wooden board with a clerical knife.
Step 5
Sand all cut edges with fine emery paper to remove any burrs and irregularities. Also, thoroughly sandpaper the entire surface of the bottle, firstly, so that it becomes rough, and secondly, to remove inscriptions from it that can show through the material with which you will decorate the plastic stand. A rough surface is necessary for a stronger adhesion of the adhesive and plastic.
Step 6
Now take a flap of bright, interesting fabric, enough to wrap the entire stand (first try this and remember how the fabric lies approximately). Place the flap face down.
Step 7
Spread a thick layer of PVA glue on the front of the stand and press it against the fabric in the place that you predetermined. Then apply glue to the sides of the stand and the back and wrap them with a cloth, pulling it tightly, like a film, so that no wrinkles and air bubbles remain. Bring the fabric to the bottom as well, try to fix it well in the shape of the bottle. Do not feel sorry for the glue.
Step 8
When the fabric is evenly distributed and glued on all sides of the product, except for the bottom, carefully cut off the excess with scissors close to the edges. Apply another layer of glue.
Step 9
Cut a piece of fabric to fit the bottom of the bottle and glue underneath, covering the cut bottom edges of the fabric. Cover the bottom with an additional layer of PVA glue.
Step 10
Place the product to dry so that it does not come into contact with anything (on a suitable hook, on a pencil or spoon in a glass, etc.). When the stand is dry, use a utility knife to cut a hole in the holder. Check if the fabric holds well on the cuts. Glue backing edges if necessary.
