Even a novice angler cannot go fishing if he does not know how to connect two lines. The knot called "bloody" will allow you to easily connect the lines, it has a small diameter, easily passes through the guide rings of the spinning rod, and has a tensile strength of up to 75%.
It is necessary
- - metal strips;
- - wire.
Instructions
Step 1
To tie two fishing lines with a "bloody" knot was easier, you can make a special device. It is a double clothespin clip. This device is made of three strips of metal, which are twisted at the bottom with wire. The strip in the center is straight, and the other two are bent from it at an angle of 25-30 degrees. Such a clamp allows you to clamp the fishing lines so that during the execution of the turns they are motionless and not confused with each other.
Step 2
Place the lines you want to tie between the clamp plates, with one line between the first and second plates and the other between the second and third.
Step 3
Wrap the end of one line around the other 4-6 times. The number of turns depends on the thickness of the line - if it is thin, there should be more turns and vice versa. Fishing line with a thickness of up to 0.15 turns in 6 turns, up to 0.27 - in 5 turns, and for a fishing line with a thickness of 0.3 and more, 4 turns are enough. If you tie a braid, it wraps in 2-3 turns.
Step 4
Wrap the end of the line that you wrapped around the other. Slide it between the lines at the point where the turns begin, near the clamp itself.
Step 5
Wrap the second line around the first in the same way as you did in the first step. This must be done on the other side of the clamp. Take the end of the second line and thread it through the loop in the middle. You need to thread the second line so that it is directed in the direction opposite to the direction of the end of the first line.
Step 6
Moisten the knot you have made and carefully pulling the fishing line by the long ends, tighten it tighter. Trim the excess as close to the knot as possible.
