In addition to the traditional Christmas tree, miniature versions of the New Year's beauty can also decorate your home. To make them look no worse and also please the eye, you can use LED garlands to make them.
The traditional large Christmas tree has been replaced by its miniature versions, made from a variety of materials. The Christmas tree made of LEDs looks the most festive. There are several ways how to make an LED Christmas tree with your own hands. At the same time, the Christmas trees look different from each other and original.
LED herringbone on the wall
The simplest and easiest way to make an LED Christmas tree does not require much effort. To make such a tree, you will need an LED garland, pushpins and photographs or small plastic toys. The tree will decorate the wall.
The buttons must be fixed at the top of the spruce, at the ends of its legs and at their base. Mark the middle of the LED string and attach it to the top button. Then pass both ends of the garland through the buttons, depicting a Christmas tree. You can decorate such a tree with light balls, toys or photographs. Turn on the LED string and admire the new tree.
LED Christmas tree from a bottle
The original Christmas tree with LEDs can be obtained on the basis of an empty champagne bottle. In addition to the bottle, you will need a drill, drill, plasticine, glue, LED string lights, and parchment paper.
The bottle must be cleaned of the label and rinsed. Fix the prepared bottle on the work surface with plasticine. At the bottom of the bottle, cover the drilling site with plasticine. Start drilling the hole. After a small notch forms, put a few drops of water into the hole. This is to prevent the drill from getting too hot. Drill the hole all the way. Remove all the clay, rinse the bottle and wipe it dry.
Pass the string through the drilled hole and fill the bottle with it. To make the product more like a herringbone, roll the white parchment paper into a cone, secure the edges with glue. Include a garland. This completes your Christmas tree.
LED Christmas tree made of floral mesh
This Christmas tree in appearance will resemble a Christmas tree from under a bottle of champagne, but it will look more aesthetically pleasing. To make a Christmas tree, you will need a floral mesh, thick cardboard, cling film, scissors, PVA glue, a brush, sewing needles, an LED garland and decorations for the Christmas tree.
From cardboard you need to twist a cone of the desired height. Cut the floristic mesh into strips. Dissolve PVA glue with a small amount of water in a container. Wrap the cardboard cone with cling film, cut off the excess. Soak pieces of floral mesh in a solution of glue, and apply them to the cone, fastening with sewing needles. After the first layer of mesh is dry, lay out the second in the same way. Leave the cone to dry completely.
After that, remove the cone from the mesh from the cardboard structure, and carefully remove the film. Place an LED string inside the cone and decorate the whole Christmas tree with toys.
