Where to start if you have a desire to make a robot with your own hands? First of all, the first models made for you should be very easy to create, do not require special skills and abilities. Try making a mini or vibro robot.
It is necessary
- To create a simple mini robot:
- - engine;
- - 2 wiring;
- - glue;
- - 2 small pieces of foam board;
- - insulating tape;
- - toothbrushes or paper clips;
- - beads for the eyes;
- - AA battery.
- To create a simple vibrobot:
- - Light-emitting diode;
- - motor;
- - CR2032 battery;
- - CR2032 battery holder;
- - soldering iron;
- - insulating tape;
- - paper clips.
Instructions
Step 1
To make a simple mini-robot, first glue a small piece of foam board to the engine. After cutting off a strip of cardboard, glue a bead on one end of it. When the glue is dry, stick the other end of the strip onto the engine.
Step 2
Now you can start creating the robot legs. Ordinary toothbrushes will serve as his lower limbs. Glue foam board on their smooth surface, and then let it dry. After that, glue the motor to the brushes.
Step 3
Solder the wires to the motor terminals. Then glue the battery to its upper surface, to which attach the bead eyes. Attach one of the previously soldered wires to one end of the battery. Then, using electrical tape, attach another wire to the opposite end of the battery.
Step 4
To make a simple vibrobot, first wrap the LED with electrical tape, leaving the tip intact. Then, solder one wire of the LED to the bottom surface of the battery holder. Other wiring needs to be soldered to the contacts of the motor.
Step 5
Next, unfold the paper clips and make them look like insect legs. Cut off excess staples and solder the resulting wire legs to the motor. You can wrap the lower limbs of the robot with electrical tape. This will avoid scratching the surface on which the robot will move.
Step 6
After that, connect the wires of the battery holder to the wires of the motor. Now, when you insert the battery into the holder, the device you created will begin to move. That's it, your simple vibrobot is ready.
