Many devices can be made at home with your own hands. For example, you can make a device for preparing live and dead water. Living water is water charged with a positive charge, dead water - negative. Drinking living water helps to rejuvenate and cleanse the body.
It is necessary
- Two plates made of food grade stainless steel, 5 cm wide, 15 cm long.
- Semiconductor diode.
- Plastic case with removable 20 cm lid.
- Wire with a plug.
- Two cans of water.
- Wires.
- Screws.
Instructions
Step 1
Attach two stainless steel plates to the plastic case. To do this, cut two parallel slots in the bottom, into which the plates can pass. The slots should be at opposite ends of the plastic case. Then insert the plates into the slots and secure them with screws.
Step 2
Place a semiconductor diode in a plastic case and connect it to the stainless steel plates with wires. Mark on the outside of the plates where the minus is and where the plus is.
Step 3
Make a hole in the plastic case for the wire with the socket. Insert a wire into it and attach it to the semiconductor diode. Close the housing with the lid.
Step 4
Fill 2 jars with water. Place them side by side. Dip the apparatus for preparing live and dead water in jars so that each of the electrodes (plates) is in a separate jar. Plug in the device and leave for 10 minutes.
Step 5
Unplug the device from the mains. Take it out of the jars. Pour out the "dead" water, drink "live".
