Children often like improvised toys even more than purchased toys. And this is understandable: the toy is made together with mom or dad, adults put part of their soul into it. And no one has such a toy. There is always material for making a toy car at home or in the yard.
It is necessary
- - Matchbox;
- - PVA glue;
- - glue "Moment" or any universal;
- - colored tape or remnants of self-adhesive films of different colors;
- - 4 small bottle or bubble caps;
- - a piece of wire or knitting needle;
- - awl;
- - scissors;
- - knife.
Instructions
Step 1
Open the matchbox. Make a cab out of the cover, and a body out of the box. To do this, just put the lid vertically and glue it to the smallest part of the box. The bottom lines of the cab and body must be at the same level, otherwise it will be problematic to put the car on wheels.
Step 2
Cut out the bottom of the body. You can first draw everything you did on paper. Paste over the body from the outside and from the inside. Cut out 2 rectangles equal to the area of the bottom. Stick them on the inside of the box and on the bottom. Cut a strip that is the same length as the perimeter and the width is the height of the body. Stick it on the inside of the body. For the outer part, cut the same strip, only without one short side.
Step 3
Start pasting the cab from the top plane. The rectangle should be slightly larger so that you can stick it on the edge of the box. Glue the same rectangle below. For the sides, cut a tape that is the same width as the height of the cab and the length of the perimeter without the back wall. For the rear wall, cut a rectangle from the top of the cab to the body. Make small squares out of scotch tape or film of a different color. You can also make doors by gluing rectangles to the sides of the cab.
Step 4
Use an awl to pierce through the cabin. The punctures should be approximately 0.5 cm from the bottom line, approximately in the middle of the cab. Make the exact same punctures on the body, stepping back from the back line the same distance. The size of the holes should be such that the drag can freely enter there.
Step 5
Cut off 2 axles from a piece of wire. Their length should be slightly more than the width of the machine, so that the wheels can be attached there, and there is still a gap. Insert the pieces of wire into the holes in the cab and body. Lubricate the ends with glue and glue the small bottle caps with the outside of the bottle.
