How To Make A Bracelet From Beads And Wire With Your Own Hands

Table of contents:

How To Make A Bracelet From Beads And Wire With Your Own Hands
How To Make A Bracelet From Beads And Wire With Your Own Hands

Video: How To Make A Bracelet From Beads And Wire With Your Own Hands

Video: How To Make A Bracelet From Beads And Wire With Your Own Hands
Video: 3 Strand Braid bracelet from copper wire and small crystal - How to make handmade jewelry 488 2024, November
Anonim

Beautiful jewelry complements the image and attracts additional attention, but only original accessories can make the style unique. If your heart does not lie with purchased jewelry, make a bracelet from wire and beads with your own hands.

DIY bead and wire bracelet
DIY bead and wire bracelet

It is necessary

  • - square wire
  • - round wire of smaller diameter
  • - beads
  • - round nose pliers
  • - pliers
  • - transparent glue

Instructions

Step 1

Using pliers, separate 5 pieces of 23 cm long from the skein of square wire. Measure 2.5 cm from each edge and mark with a felt-tip pen. Grasp the end of the wire with round nose pliers and twist the flat spiral to the mark. Repeat on the remaining blanks.

wire spirals
wire spirals

Step 2

Place the pieces of wire back to back. Make sure that there are no elements lying on an edge. Measure a piece of round wire enough for 6 turns around the base pieces. Make a wire hook at the end of a thin wire, put it on square blanks and, starting from the base of the spirals, make 6 turns. The beginning and end of the round wire should be on the same plane - this will be the inside of the bracelet.

connection of parts
connection of parts

Step 3

Measure 2.5 cm and slightly bend one square wire on each side, put a bead on them and reconnect all the elements. Cut a piece of round wire and wrap around the base as in step # 2. Watch out for the ends of the thin wire - they should be on the same side.

wire bracelet
wire bracelet

Step 4

Mark an 8 cm segment. Bend back the twigs of the square segments and string 5 beads on each wire. If you want to fix a certain position of the beads, use transparent glue. Connect the elements again into one bundle at the marked point. Repeat wrapping 6 turns with fine wire.

wire and beads
wire and beads

Step 5

Repeat steps 3, 2 then wrap the ends of the wire in spirals as in step 1. Shape the bracelet into a semi-circular shape and wear with pleasure and pride.

finished bracelet
finished bracelet

Step 6

Using this method, but changing the size and number of beads, you can create unique and unique bracelets with your own hands.

bracelet made of wire and beads
bracelet made of wire and beads

Step 7

The wire can be patinated at the end of the work and then your jewelry will take on the appearance of an antique jewel.

Recommended: