How To Mold A Fox From Plasticine

Table of contents:

How To Mold A Fox From Plasticine
How To Mold A Fox From Plasticine

Video: How To Mold A Fox From Plasticine

Video: How To Mold A Fox From Plasticine
Video: How to make a cute Fox Cake Topper - Cake Decorating Tutorial with Cake Dutchess 2024, November
Anonim

The fox is a character in many Russian fairy tales, therefore, when sculpting a plasticine theater, there is often a need to create this red-haired beauty. Having mastered the skills of sculpting a fox, you can also make a wolf - another popular hero of fairy tales.

How to mold a fox from plasticine
How to mold a fox from plasticine

It is necessary

plasticine of orange, white and black colors

Instructions

Step 1

Make blanks for subsequent sculpting. Make 1 ball for the head from orange plasticine, two sausages for the body and tail, two long sausages - thin for the front legs, thick for the hind legs. Cut the paw sausages in two with a plasticine spatula or disposable plastic knife.

Step 2

Shape the body parts of the chanterelle. Start with the head, from its size you will build on when sculpting the torso and legs. Take a plasticine ball, pull back the nose with your thumb and forefinger. Create the ears as well. From a piece of plasticine intended for the tail, mold something in between a diamond and an oval. Make the legs thinner at the bottom. At the torso sausage, extend the neck, round the back. Make sure that the body parts are proportional to each other. If the tail or torso is disproportionately large, pinch off a piece of plasticine.

Step 3

Pinch off a small piece from a white block of white plasticine. Roll it into the thinnest oval layer, attach it to the part of the body that will be the breast. Roll another white piece into the thinnest oval, wrap the tip of the tail with it, press. Using a smear motion towards the base of the tail, attach it. Form thin cakes from black plasticine, wrap them around the lower parts of the paws, press firmly, spread the black plasticine towards the top of each paw. Place a small round piece of black plasticine on the nose.

Step 4

Put the fox together. If the clay is sticky enough, you can just press the parts tightly together. If it is not very sticky, it is necessary to smear the parts attached to the body - the paws in the upper part, the tail at the base. Place your head against your neck and use movements in both directions to connect these parts. Roll up small black eyes and place them on the chanterelle's head.

Recommended: