You can make many beautiful and original things with your own hands. Try making your own paper clock. It won't take much of your time. In addition, children can be involved in this exciting activity.
It is necessary
- - clockwork;
- - compass and ruler;
- - thick paper.
Instructions
Step 1
First, prepare the foundation for the future hours. Use two colors of paper that are wider than
the size of the future dial is a rectangular base from a set for making watches. Will be better, if one sheet has a floral or other unusual pattern, and the other has a solid color.
Step 2
Cut about 10 strips from different sheets of paper. Make strips thinner on one side than on the
other. Place the pieces of paper over the dial to make sure there are enough stripes.
Step 3
Apply a thick layer of special decoupage glue to the dial with a brush. Glue
strips of paper, alternating colors. Try to keep the edges of the paper slightly on the back side
dial on four sides. Smooth out the glued strips gently to get rid of bubbles
air. Carefully cut off the points where the arrows are attached. Let the glue dry. Then flip over
color face down and glue the excess paper edges on the back of the watch.
Step 4
Then cover the surface of the dial with the same glue in several layers, allowing time to dry until
applying a subsequent layer. This will give the surface a glossy shine, since the decoupage glue
combines the properties of varnish. In addition, the watch will be protected from damage.
Step 5
After all layers of glue are completely dry, start making the dial markings. For
For this, use a paper plate of the correct size. On the back of the plate with
with a ruler and pencil, draw lines at equal intervals. Namely, after drawing six lines, you
get 12 points along the entire circumference of the plate, which will correspond to the position of the numbers on
hours.
Step 6
Place a paper plate in the center of the dial. You can write nicely
Roman or Arabic numerals, as well as come up with a suitable replacement for them in the form of buttons, beads, rhinestones
and much more. Use strong glue to glue the buttons. Remove the paper plate and
leave your workpiece to dry.
Step 7
To make the hands match the overall look of the watch, paint them to match the buttons, then cover them
several coats of clear acrylic varnish.
Step 8
Install the arrows following the manufacturer's instructions. You just have to put in the batteries, set the exact time and hang the clock on the wall.