Refueling the sewing machine is easy, you just need to carefully and patiently follow the instructions
It is necessary
sewing machine, a little patience
Instructions
Step 1
Different sewing machines are refueled in approximately the same way.
It takes a little practice and patience to feel confident in this process. Also be careful not to get your fingers under the sewing machine needle.
The upper thread must be threaded first. To do this, place the thread from the spool on the bobbin holder, then thread the thread into the bobbin holder. Thread the thread from the thread guide into the hole in the thread guide located on the arm of the machine. From the thread guide, feed the thread into the thread guide on the front of the machine. Then pass the thread through the groove behind the front board, this will bring it to the upper thread tension regulator. After that, thread the thread between the washers of the tension regulator and beyond the end of the compensation spring, and then thread it by the hook of the thread guide. Then pass the thread through the thread guide and thread into the eye of the needle. Thread the thread into the eye of the machine needle from the side of the long groove. Leave the loose end of the thread about 10 cm long and slide it under the presser foot.
Step 2
After that, you can start threading the bobbin thread. This is not a very difficult process. Wind enough thread around the bobbin. This can be done manually, although some machines have a special attachment on the side. Insert the bobbin into the bobbin case. Then thread the slit and insert the bobbin case into the hook. Then, while gently holding the upper thread, turn the handwheel one turn. Interlacing of threads should occur. While pulling on the end of the upper thread, bring the lower thread up the throat plate. Pass the ends of both threads through the presser foot. The filling operation can be considered complete.
