How To Make A Bow For A Girl

Table of contents:

How To Make A Bow For A Girl
How To Make A Bow For A Girl

Video: How To Make A Bow For A Girl

Video: How To Make A Bow For A Girl
Video: How To Make A Hair Bow 2024, November
Anonim

Matinee in kindergarten, September 1, even the holiday of the last bell, when your almost adult daughter wants to be a little girl for another day … Young ladies have plenty of reasons to tie a beautiful bow. You can, of course, tie it up, as the grandmothers and great-grandmothers of the current little princesses did. But if the hair is short, then it is better to make a bow and pin it.

How to make a bow for a girl
How to make a bow for a girl

It is necessary

  • - wide and long nylon or satin ribbon;
  • - several tapes 2.5-3 cm wide;
  • - several narrow satin ribbons;
  • - unnecessary pencils;
  • - needle and thread;
  • - scissors;
  • - clothes pegs;
  • - simple spring clip.

Instructions

Step 1

If your hair is long and heavy, it is better to tie the bow. He decorates his hair and holds his hair. However, take a ribbon one and a half times longer than you usually weave. Fold the ribbon in half, braid the braid exactly as you always do, and braid the ribbon. A double or even triple bow will look elegant, so the ribbon should have rather long ends. Tie them in a single knot, then grab the braid with them in the opposite direction and tie again. Divide the remaining ends of the tape into 4 pieces in your mind.

Step 2

Make loops around the index fingers so that they are 1/4 the length from the braid. Hold the ends of the tape along with those parts that adjoin the braid with your middle and thumbs. Tie a single bow. Then fold the ends of the ribbon in the middle of the remaining pieces and tie another bow. Straighten both bows so that you get a cross. Long ends can be curled with a warm curling iron.

Step 3

The bow can not only be tied, but also pinned. And here there is a lot of room for imagination. Take tapes of several types. For example, wide nylon and narrow satin, matching in color. Tie a large single or double bow from a nylon tape. You can use two colors of ribbons. Cut the same pieces. Fold the ribbons together by aligning the edges. Tie a single bow and straighten.

Step 4

Wrap narrow satin ribbons on a curling iron. Let them sit for a few minutes, then straighten them out. If you don't have a curling iron at hand, wind them in a spiral onto pencils, secure with clothespins and put them in the oven for about fifteen minutes. The temperature must be at least 100 ° C.

Step 5

Sew the satin ribbon “curls” to the bottom of the bow knot. Try to do this so that the curled ribbons run in different directions. Attach the entire structure to the spring of the hair clip. Actually, you only need a spring with a latch from it, so it's very good if there is a hairpin with a broken top. The bow should sit tight enough not to fall off at the most crucial moment. If there are holes in the spring, this will give you extra convenience. Sew the bow as you would normally sew on a button or button.

Recommended: