Balloons have always been the favorite toy of children. Long thin balls delight the little ones, because you can make a lot of funny things and characters from them. For example, a dog.
It is necessary
- - balloons for modeling
- - pump
Instructions
Step 1
Before tinkering a dog in front of children, practice a little alone. This will save you from potential public failure and children from disappointment.
Step 2
You cannot do without a pump in this matter. Even the strongest lungs cannot generate the pressure required to inflate a long, thin balloon with relatively thick walls. Take a balloon for modeling, inflate it, but not completely.
Step 3
Leave a small “tail” about 8-10 cm at the end of the balloon, otherwise the balloon will burst during modeling. Tie the hole in a regular knot with your fingers.
Step 4
Step back 5 cm from the knot, twist the ball in this place 3-4 times. Holding the resulting "sausage" with your hand, make another one next to it, exactly the same. Fold them together, connect the knot and the last twist in the same twist.
Step 5
You already have a dog's face ready. Make the ears of two sausages in a similar way. Twist the muzzle and ears together so that an angle close to perpendicular forms between them. The head is ready.
Step 6
The next sausage will be single, and it will play the role of the neck.
Step 7
Make legs from two segments according to the method with which you have already made the muzzle with ears.
Step 8
If you succeed, then you can do the rest without a prompt. One segment for the body, two for the hind legs, the last segment remaining will act as the tail.
Step 9
When you make the dog, you will notice that the supply of the balloon left by you when you inflate is almost exhausted. If this does not happen, it's okay, make a poodle out of the dog. Push some of the air from the beginning of the tail to the tip for a cute pompom.
