For every needlewoman, I think, it is important that everything is always in its place. But what a needlewoman, for any housewife this is important, especially when it comes to such dangerous things as a needle or safety pin. I suggest that you make a needle bucket with your own hands.
It is necessary
- - suitable plastic base;
- - scissors;
- - stationery knife;
- - several colors of cotton fabric;
- - decorative tape;
- - synthetic winterizer;
- - threads;
- - a needle.
Instructions
Step 1
To make this needle bar, you first need to make a plastic base for it. A shampoo bottle is suitable for this. Just cut the top off of it with a utility knife. Do everything very carefully and carefully. When the base is ready, sew it over with a light green cloth.
Step 2
Now you need to cut out the details for the berries, that is, for the strawberries. Remember that for one berry you need 2 patterns, and since we have 2 of them, then, accordingly, there will be 4 patterns in total. Do not forget that leaves should also be made for berries. Therefore, cut out 4 parts from the green fabric, which outwardly look like the arithmetic sign "+".
Step 3
The resulting parts must be sewn on the seamy side on a sewing machine. Do not forget to leave a small hole in the berries through which they can be turned out. There is no need to leave it on the leaves. They need to cut a hole in the center so that it is not through, but affects only one layer of fabric. It is through it that these parts are turned out.
Step 4
Berries must be stuffed with padding polyester. If not, then you can use cotton wool. After they are stuffed in, carefully sew up the hole left. Each wedge should be embroidered on the leaves with a dotted line. Then sew the center of the part with the same dotted line. Put a bead in the hole that was needed for turning inside out, tighten it with threads, and then sew to the strawberry.
Step 5
Strawberries with a leaf blade must be sewn to a decorative ribbon. To do this, throw it over the tape and fix it accordingly. Tie the resulting tape to the sheathed plastic base. The pincushion bucket is ready!
