Any hand-made thing is always unique, and if it is also a gift, then it is just wonderful. A postcard from the store, of course, is bright and beautiful, but you put your soul into a homemade one, and this is completely different.
It is always nice to receive as a gift a thing that is made with your own hands, because no one else has the same thing. The method below can be used to make a simple craft or, for example, a greeting card.
You can draw the basis for our craft yourself, if you are good at it or just find a beautiful picture. I've chosen large daisies. Yes, when choosing a drawing, keep in mind that it will take more time for small details. If this does not scare you, then go for it.
For my craft, I needed threads for knitting in three colors - white, yellow and green, as well as PVA glue (it is more convenient to work with a bottle) and scissors.
The threads must be cut into small pieces - 2-3 mm., You do not need to mix them, it is better to arrange them in separate piles (I put them in ordinary large can lids). It was difficult to determine the required amount, so it is better to cut a little for a start, if you can add something later.
We take our base and green threads (uncut), apply them to the flower stems and cut them to the desired length, set them aside. We glue the PVA carefully along the contour of the stem and immediately press our prepared threads. Now we take the threads (again green) and also along the contour, only now the leaves, measure the desired length, draw along the contour with glue and press the measured pieces.
The same is with the contour of the petals (only we take already white threads) and the centers of the flowers (we use yellow threads). Well, the workpiece is ready. Let's put our sliced pieces into action. First, apply a thin layer of glue to the parts of the craft, and then sprinkle with threads and press. On the petals - pieces of white threads, on the middle of the flowers - yellow, on the leaves - green. To make the craft more voluminous, you can make several layers, you just need to wait until it dries completely. I did it in two layers. Everything.
