Each person made paper airplanes. But business, as a rule, does not go beyond the manufacture of simple models. Meanwhile, the shapes of flying paper airplanes can be completely different. The longest flying aircraft is the wing-shaped fighter.
To make a fighter plane, you need a sheet of paper 340 × 340 mm, scissors, glue and a ruler.
1) Bend two opposite corners towards each other and iron the fold with your hand. Do the same operation for the other two rows.
2) Fold a square piece of paper in half and unfold it.
3) Bend the outer corners towards the middle of the workpiece.
4) Fold the wing blank in half and iron the fold line by hand.
5) Lift up the top, giving it a rectangular shape. Divide the rectangular piece into 3 line segments. The third segment must be at least the sum of the lengths of the other two segments.
6) Cut the upper part to the middle of the part with scissors along the marked lines.
7) Bend the second and third petals in different directions from the workpiece. Expand the first petal in front of the details.
8) Fold the left and right sides of the first petal in half and glue.
9) Bend the glued part to the right.
10) Fold the triangles over to the glued part. The resulting part is called the fighter's stiffener. For him, the plane should be launched into flight.
11) It is necessary to make cantilever keels for the fighter. To do this, bend the bottom corners 40 mm to the center of the part.
12) Press the keels from the sides so that they turn out to be voluminous.
13) Glue the cantilever keel to the aircraft fuselage.
14) Glue the trailing edge of the fuselage together. It is best to use a glue stick. When using it, there will be no warping of a sheet of paper.
15) Roll the second petal into a tube. One part of it is glued to the wing surface, and the other is covered with glue. This surface is shaded in the figure.
16) Bend the third petal back.
17) Roll the third petal into two tubes.
18) Glue the tubes in the center.
19) To give a fighter better flight performance, it is necessary to make its nose heavier. Cut out a triangle with a base of 90 mm and a side of 65 mm.
20) Glue the cut out triangle to the bow.
21) To make ailerons, cut the rear of the fighter fuselage and fold it up.
