In Adobe Photoshop, you just need to draw an ordinary spring. In addition, here you can give it various effects and take into account the necessary proportions.
It is necessary
- - Adobe Photoshop program;
- - skills in working with Adobe Photoshop.
Instructions
Step 1
Open Adobe Photoshop. Select the Selection tool. Make two selections on different layers with specific specified dimensions. They must be of different heights and the same width (see picture). Circle each one. For example, use a 5 px stroke. Use a different color for clarity. Place the guide and erase in half as shown
Step 2
Select the Move tool, hold alt="Image" (to copy) and move from layer to layer, lifting these halves up and aligning (as shown in the picture). In the process of each such copying, a new layer should lie above all layers
Step 3
Select any layer by double clicking on the layer. Set up different effects in layer styles, for example, metal. Then again hold the alt="Image" key and transfer the resulting style to the rest of the layers (grab the fx cursor and hold down the alt="Image" key in the layers palette and transfer it to the others, see the picture)
Step 4
Draw a spring of any width, make as many curls as you like, experiment with metallic styles, etc. At the ends of the spring, you can draw elliptical circles with the brush tool.
Step 5
Draw the spring in a free state on the basis of the fact that the part should not give the impression that it is under pressure from the outside. It is better to draw the contour of the turns with simplified straight lines.
Step 6
Draw the section of the coil springs with the section of the turns. If the thickness of their section is less than two millimeters, then when depicting a spring in a section, fill the section completely with a dark color, if this parameter is less than 1 mm, depict the section schematically.
Step 7
If you are building a drawing with the specified parameters, be extremely careful: focus only on the calculated values.
