Baubles are hand-woven bracelets from a variety of materials. It can be beads, multi-colored ribbons, floss threads and other sewing accessories. There are quite a few ways and patterns of weaving. For weaving, two techniques are used, oblique and straight, which can be performed both on the frame and on the lace. To weave a bauble from a floss, you must adhere to certain rules.
It is necessary
Multicolored floss threads, pins, scissors
Instructions
Step 1
First of all, prepare materials and tools for the job (threads, pins, scissors). The most important rule for creating a floss bracelet is that the number of working threads should be even, and their length should usually be 1 meter or 4 times the length of the finished product.
Step 2
Weaving from floss threads is quite simple, so this type of needlework is available even to the most inexperienced beginners. To begin with, you need to make a loop of the future baubles there was a clasp, then before starting weaving, you need to fix the threads on the buckle.
Step 3
In order to avoid twisting the product, fix the base of the bracelet with a pin, in the place where it will be convenient for you to continue working.
Step 4
The simplest oblique weaving pattern is performed from left to right. Tie two knots with the first thread around the second. Then continue working with the same thread to the end of the row, tying two knots on each subsequent thread. As a result, multi-colored stripes will appear with each row. Continue working in this way until the desired length of the bracelet. The end result of combining colors will depend on how you combine them. Usually, two threads of each color are used (for example: 2 threads of green, 2 threads of red, 2 threads of yellow).
Step 5
After the bauble has reached the desired length, braid two pigtails, and fix them with knots at the ends. If the product is made with a buckle, then tie the threads in pairs, then bend the ends inside out and sew with small stitches. As a result, the bracelet should be 2 cm shorter than the wrist circumference. From leather or leather substitute, cut two strips to make a strap equal to the width of the bracelet. Sew them so that the bracelet is inside the strap. The bracelet is ready, it remains only to make a hole with an awl for fastening in the right place. Wear it to your health.
