It is very important that the ears and neck of the child are warm in any weather. A winter hat-helmet perfectly solves this problem. When a child is wearing such a helmet, you can safely go for a walk on a cold and windy day.
It is necessary
- - knitting needles (No. 3, straight);
- - 100 g of woolen threads (thread length - 400 m);
- - a piece of sticky tape, thread with a needle.
Instructions
Step 1
Tie the cap over the ears and the collar to it like two pieces, then join them together. Perform the product with the front satin stitch, the hat consists of three wedges, each divided into two parts. At the end of knitting, you should get a strip with a zigzag edge at the top and bottom, then the top edge and sides are sewn together.
Step 2
Cast on the knitting needles 122 loops: 1 row - remove the first edge as the front one, make a yarn, 19 front loops, then knit 2 loops together, front 20, 1 yarn, 18 front loops, 2 front loops together, front 18, 1 yarn, 20 front, 2 loops together front, 19 front, hem - purl.
Step 3
Repeat the specified knitting sequence, performing all purl rows - purl, knit - knit. When the height of the fabric reaches 16 cm, close the last row, fasten and cut the thread, sew the top and sides.
Step 4
Tie the collar of the helmet, from the wider hem to the narrower part where the collar will be sewn to the helmet. Cast on 128 stitches, knit in stitch, in the second (purl) row mark 14, 28, 42, 56, 70, 84, 98, 128 sts. In the third row, start the decreases, knitting the marked loop together with the previous one, repeat the decreases through the row seven times.
Step 5
Close the last row of the collar and sew to the helmet in this way: fold the hat so that the back seam is in the middle of the back, there will be a wedge in front with a prong down, on the sides - the halves of the other two wedges, in the back - the second halves of these wedges, to which you need to sew the collar. The collar is wrapped in front; Sew pieces of Velcro tape to the ends for fastening.
